Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
Showing results for 
Search instead for 
Did you mean: 

Vlans Cisco to 2824

Occasional Visitor

Vlans Cisco to 2824

I'm trying to trunk a 2824 to a Cisco 4006 Chassis. I set the trunk lines but as soon as I plug the trunk line in I can no longer see the 2824...Here's the main parts of the configs...Port 1 will trunk to the cisco 4006 6/1.

#module 6 : 48-port 10/100/1000 Ethernet
set trunk 6/1 on dot1q 1-1005,1025-4094
set trunk 6/2 on dot1q 1-1005,1025-4094
set trunk 6/3 on dot1q 1-1005,1025-4094
set trunk 6/4 on dot1q 1-1005,1025-4094
set spantree portfast 6/1-10 disable

; J4903A Configuration Editor; Created on release #I.10.43

hostname "ProCurve Switch 2824"
web-management management-url ""
interface 1
no lacp
interface 21
no lacp
trunk 1,21 Trk1 Trunk
ip default-gateway
snmp-server community "public" Unrestricted snmp-server host "public"
snmp-server host "public"
vlan 1
untagged 2-20,22-24,Trk1
ip address
vlan 3
name "internal"
tagged 2
vlan 4
name "classrooms"
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-HDx sensitivity high
fault-finder duplex-mismatch-FDx sensitivity
high spanning-tree Trk1 priority 4
Christian Borén
Occasional Visitor

Re: Vlans Cisco to 2824

on HP Procurve devices you need to use tagged ports instead of trunking. Trunking in Procurve is used for load-sharing/bonding ports.

So if you want to use several vlan's on a port you set it up as tagged.


tagged 1
tagged 1
tagged 1

Occasional Visitor

Re: Vlans Cisco to 2824

That worked. Thanks.

ps. Also found out that you need to do it from the menu interface, not the web interface. For some reason the web interface shows they are tagged and the conf is correct even though they are not. Had to telnet into the switch, run menu, tag and untag then save. Then everythign was correct.