HPE Community
Switches, Hubs, and Modems
1752801 Members
5764 Online
108789 Solutions
New Discussion юеВ

Web management on 2600, 2800 and 5300

 
SOLVED
Go to solution
Jonathan Axford
Trusted Contributor

тАО11-15-2006 10:41 PM

тАО11-15-2006 10:41 PM

Web management on 2600, 2800 and 5300

Hi guys,

I have been looking at the web management setups on our switches. It seems that our 2500 and 4100 switches prompt for the username and password before even opening up the web page, whereas the 5300,2600 and 2800 all open up the page and only prompt for authentication when a channge is tried.
Is there any way to get these to prompt for auth. before showing any information at all?

We have lots of inquisitive students here and i would rather they couldn't see any info at all!

Many thanks

Jonathan
Where there is a will there is a way...
0 Kudos
2 REPLIES 2
Mohieddin Kharnoub
Honored Contributor

тАО11-15-2006 10:58 PM

тАО11-15-2006 10:58 PM

Solution

Re: Web management on 2600, 2800 and 5300

Hi

Setup the Operator password.

Good Luck !!!
Science for Everyone
0 Kudos
Jonathan Axford
Trusted Contributor

тАО11-15-2006 11:02 PM

тАО11-15-2006 11:02 PM

Re: Web management on 2600, 2800 and 5300

Thanks very much, is working fine now.
:-)
Where there is a will there is a way...
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.