- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- how should I configure sflow sampling?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-06-2019 01:27 AM
08-06-2019 01:27 AM
how should I configure sflow sampling?
I'm reading the sflow section here:
https://support.hpe.com/hpsc/doc/public/display?docLocale=en_US&docId=emr_na-a00040098en_us
to configure sflow in order to reach ManageEngine netflow analyzer I should configure sflow sampling.
so I give the following cli commands:
system-view
then I have to chose Layer 2 Ethernet interface view/Layer 3 Ethernet interface view.
If I try:
interface Ten-GigabitEthernet 1
^
% Wrong parameter found at '^' position.
interface GigabitEthernet 1
^
% Wrong parameter found at '^' position.
I don't understand what should I insert.
And after that i should set sampling rate but I can't find such command:
sflow sampling-rate ?
^
% Unrecognized command found at '^' position.
sflow ?
agent Specify sFlow Agent
collector Specify sFlow collector ID
source Specify sFlow source
Can someone please explain what I'm missing?
Kindest Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-06-2019 06:28 AM
08-06-2019 06:28 AM
Re: how should I configure sflow sampling?
Hello
Greetings!!
Please define the vlan interface before your define a switch interface
For detailed procedure, please refer to page 161 in the below link :
https://support.hpe.com/hpsc/doc/public/display?docLocale=en_US&docId=emr_na-a00040098en_us
Also make sure, you have a latest code on the switch, just to rule out any software related bugs
I hope this helps!!
Thanks