Switches, Hubs, and Modems

Re: lost packets on new HPE 1950 12XGT J295H

 
SOLVED
Go to solution
Nicolas967
Occasional Advisor

lost packets on new HPE 1950 12XGT J295H

hello,

I just unpacked 2 switches HP 1950 XGT.

I plug them into my LAN, they get an IP address via DHCP.

I connect well to the web interface to configure them but I constantly lose packets and I am therefore constantly disconnected.

Unable to configure switches. I tried to connect a pc directly but I have the same problem of packet loss. Unable to upgrade firmware via web interface due to connection loss.

Thanks for your help.

Nicolas

3 REPLIES 3
parnassus
Honored Contributor

Re: lost packets on new HPE 1950 12XGT J295H

Hi! instead of just connecting them directly to your existing LAN...did you tried to configure both through theirs (Serial) Console port? just to check theirs configurations and to understand if there is a reason for your issue.

I'm not an HPE Employee
Kudos and Accepted Solution banner
Nicolas967
Occasional Advisor

Re: lost packets on new HPE 1950 12XGT J295H

Yes i tried.

I also reset the switch with the factory configuration via the console port. But without effects ...

I also thought about a port alignment problem but that is not it either.

Nicolas967
Occasional Advisor
Solution

Re: lost packets on new HPE 1950 12XGT J295H


finally i managed to upgrade the firmware via the console port and the problem disappeared.