no interface all LACP - Cannot use a member of a trunk

[Les Ligetfalvy]

On 5308 with J4878 Mini-GBIC Module, if I have not fully populated with GBICs, the command:
no interface all lacp

returns the error:
Cannot use a member of a trunk

[Einar_3 · Accepted solution]

On previous firmware releases the workaround for this bug was to populate each slot with a miniGBIC one at a time an run the no int xx lacp command.
Perhaps this is solved in the last firmware, have you tried download H.08.50 ?

Einar

[Les Ligetfalvy]

Sorry, forgot to mention that I did work around it by populating with a GBIC. My post was meant to be more informational than an actual question.

I am running E.8.42 and did DL E.8.50 but have not flashed them yet.

Thanks