HPE Community
Switches, Hubs, and Modems
1752735 Members
5759 Online
108789 Solutions
New Discussion

procurve 2626

 
ammadeyy
Contributor

‎11-22-2005 03:56 AM

‎11-22-2005 03:56 AM

procurve 2626

LAN subnet 192.168.0.1
POS subnet 192.168.0.2

both subnets are connected to procurve 2626

POS is connected to one port1

i dont wont POS machines to talk to port2

how can i do this?
0 Kudos
1 REPLY 1
Kell van Daal
Respected Contributor

‎11-22-2005 06:37 AM

‎11-22-2005 06:37 AM

Re: procurve 2626

I assume all ports are in the same VLAN?
If so, use source-port filtering for it.

Read all about it in the manual:
ftp://ftp.hp.com/pub/networking/software/59906024-1004-Security-ch10-Traf-Security-Filts.pdf

In short, you have to make the filter with the following command:

2626(config)#filter source-port 1 drop 2

Hope this helps,

Kell
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.