remove config lines

[Chris991]

Hello!

How can I remove config lines on ProCurve Switches (2500, 2800, 5406zl).

As example I will remove from the config the line "ip ssh version 1-or-2".

THX

[lightxx]

"no ip ssh version 1-or-2"

[Chris991]

It doesn´t works on a 2626-PWR with SW Version H.10.74


Model2626-PWR# no ip ssh version 1-or-2
Invalid input: ip

[lightxx]

sigh ...

enter: "enable" (en)
enter: "config terminal" (conf t)

then enter: "no ip ssh version 1-or-2"

[lightxx]

are you sure YOUR switch/version supports this command? i just tried "ip shh version" on an 8212zl and it seems its not supported on K* software ...

[Chris991]

Sorry! But I was also in the config mode

Here the rigt lines:
(config)# no ip ssh version 1-or-2
Invalid input: version

[lightxx]

ok. i don't get it.

if ""ip ssh version 1-or-2" is a valid command on your switch, so is ""no ip ssh version 1-or-2". as simple as that.

if that line is really in your config, tftp the config to a PC (copy startup-config tftp ....), remove the line, copy it to the switch, hit reload ...

[Chris991]

When I execute the command "show config" I see the line:

ip ssh version 1-or-2

[Chris991]

Thanks for the answers.

[lightxx]

hm. sorry then. you could probably try "no ip ssh version 2" and see what happens...