Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

seperate vlans using the same subnet

Sam at ATEC
Occasional Visitor

seperate vlans using the same subnet

I currently have three wireless backhauls (for a CCTV system) coming back to a Procurve 2524 managed switch. I need to filter broadcasting from each backhaul leg. The backhauls are currently on the same subnet as the control equipment. Is it possible to set up 3x vlans to prevent broadcasting from one backhaul to another within the same subnet or is there a simpler way of acheiving this.
1 REPLY
aojea
Frequent Advisor

Re: seperate vlans using the same subnet

You can configure the maximum of network bandwith that can be used for broadcast in every interface with the command:

broadcast-limit