HPE Community
Switches, Hubs, and Modems
1752780 Members
6174 Online
108789 Solutions
New Discussion

seperate vlans using the same subnet

 
Sam at ATEC
New Member

‎09-23-2009 10:03 AM

‎09-23-2009 10:03 AM

seperate vlans using the same subnet

I currently have three wireless backhauls (for a CCTV system) coming back to a Procurve 2524 managed switch. I need to filter broadcasting from each backhaul leg. The backhauls are currently on the same subnet as the control equipment. Is it possible to set up 3x vlans to prevent broadcasting from one backhaul to another within the same subnet or is there a simpler way of acheiving this.
0 Kudos
1 REPLY 1
aojea
Frequent Advisor

‎09-23-2009 10:24 AM

‎09-23-2009 10:24 AM

Re: seperate vlans using the same subnet

You can configure the maximum of network bandwith that can be used for broadcast in every interface with the command:

broadcast-limit
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.