HPE Community
Switches, Hubs, and Modems
1753845 Members
7703 Online
108806 Solutions
New Discussion

spanning tree failover takes 1 minute

 
Alexander Gaiswinkler
Advisor

‎06-24-2004 02:36 AM

‎06-24-2004 02:36 AM

spanning tree failover takes 1 minute

Hi,

is there a way to tune the failover of the BL20p GbE 2 switch failover times ? If I simulate a network failure (pulling a cable) the spanning tree algorithm takes about 1 minute to rebuild the spanning tree. In that time, no network connection to the blades is possible...

Any inputs welcome!

Thanks
Alex
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.