Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

supporting a cisco ip phone configuration

ProcurveLearner
Occasional Contributor

supporting a cisco ip phone configuration

I am an absolute beginner in Procuve,What i want to acheive is that ,i have one 2610 Switch,i want two VLANs,vlan100(data),vlan150(voice),
i want port 20 to form a trunk with the router, and ports 1-10 should be used to connect cisco IP phone and Pcs will be attached to the phone switch port.In cisco switch, the ip phone can learn the voice and data vlan through CDP, does 2610 support CDP.moreover some of the switches might have older firmware which donot support lldp.
What are the complete commands from default configuration.
3 REPLIES
Shadow13
Respected Contributor

Re: supporting a cisco ip phone configuration

For port 20 that connects to the router tag it on both of the vlans (100, 150)
Vlan 100
Tagged 20

vlan 150
Tagged 20

for ports 1-10 you should untag the ports on vlan 100 (data) and tag them on vlan 150(voice)

Vlan 100
untagged 1-10

vlan 150
tagged 1-10

Regards.
ProcurveLearner
Occasional Contributor

Re: supporting a cisco ip phone configuration

thanks for the reply,
Is that all i have to do (and are they the exact commands i have to enter),what about the IP phone voice Vlan configuration.
Michael_Breuer
Esteemed Contributor

Re: supporting a cisco ip phone configuration

Hello,

if your Cisco IP phones don't support LLDP the VLAN cannot be assigned by LLDP-MED. Thus you have to configure the voice VLAN ID manually on the Cisco.
VLAN assignment via CDP is not supported by Procurve switches.

Cheers,

Michael
Ingentive Networks GmbH