HPE Community
Switches, Hubs, and Modems
1752567 Members
5289 Online
108788 Solutions
New Discussion

there is any "boot set-default flash secondary" command equivalent in K.12.25?

 
Marco Lin
Occasional Contributor

‎02-23-2010 02:49 PM

‎02-23-2010 02:49 PM

there is any "boot set-default flash secondary" command equivalent in K.12.25?

There is any way to set boot from secondary as default on K.12.25 code?

boot system flash secondary it will cause immediately reboot.

Any ideas?
0 Kudos
1 REPLY 1
Ralf Krause
Frequent Advisor

‎02-25-2010 01:22 AM

‎02-25-2010 01:22 AM

Re: there is any "boot set-default flash secondary" command equivalent in K.12.25?

You can specify the default flash to boot from on the next boot by entering the boot set-default flash command.

Syntax: boot set-default flash [primary |secondary]

This command is available in global config mode.

Ralf
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.