Switches, Hubs, and Modems
1748204 Members
4185 Online
108759 Solutions
New Discussion юеВ

Re: urgent

 
maldiveboy
Occasional Contributor

urgent

switch 1, 3500yl
switch 2, 2626

port 1 of switch 1 is connected to port 1 of switch 2

switch 2 all ports can talk each other.
but switch 2, port 10 can talk with swith 2 port 10 only, how can i do this?
4 REPLIES 4
maldiveboy
Occasional Contributor

Re: urgent

i dont want VLAN
Jorge Pinto Leite
Respected Contributor

Re: urgent

what kind of cable are you using to interconnect switches? direct or crossover?

are all pc's connected by switch 1 and 2 with same network and network mask?
Mohieddin Kharnoub
Honored Contributor

Re: urgent

Hi

If you mean:
Whatever connected to port 10 Switch1 can talk to whatever connected to port 10 Switch2 only,

In this case you need a simple ACL in the 3500 to this job.

For ACLs on the 3500, check this:
ftp://ftp.hp.com/pub/networking/software/3500-5400-6200-ASG-0207-K.12.XX-10-ACLs.pdf

But on the 2600 you don't have ACLs, but
you can have IP lockdown utility that enables you to restrict incoming traffic on a port to a specific IP address/subnet and deny all other traffic on that port.

for port security on the 2600 check this:
ftp://ftp.hp.com/pub/networking/software/Security-Oct2005-59906024-Chap09-Port_Security.pdf

There is another simple way /trick,
use for both devices connected to port 10 on switch1 and switch2 a dedicated IP/Subnet different from the one used for your network, but this will not work if you need to access some other resources bu these devices.

Good Luck !!!
Science for Everyone
maldiveboy
Occasional Contributor

Re: urgent

2 switches are connected using a bridge, all pcs have same subnet mask