vLAN setup for iSCSI

[Randy Saeks]

Hi there,

I am looking to setup vLANs for our iSCSI Network. Currently, I have the network setup in a 10.15.0.0/16 setup. I would like to add in a 172.16.0.0/24 subnet for our iSCSI traffic.

One switch, our 4208vl has ports G3 and G4 LACP'd to trk2. Another switch, a 2610 will have two of the 1000/T ports lacp'd as well.

How would I put trk2 on the 4208 and trk1 on the 2610 together on the same vlan?

Thanks.

[Yan Henrichon]

Hi Randy.

On your 4208vl, you'll have to go to config level and edit the vlan you want to use.

Let's say that you want to configure VLAN 10:
switch 4208 (VLAN 10)# tagged trk2
switch 2610 (VLAN 10)# tagged trk1

hth... Yan

[Randy Saeks]

Thanks for the info :)

I ran the commands on both switches, and if I run a sh vl 10 on both switches, I see the corresponding ports.

Is there anything that I need to do now between the two switches so they know about the vlan 10?

Also, now if I wanted to assign a separate IP scheme to the vlan, is that just running an ip add command on each switch's vlan 10 interface?