Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

vlan routing problem

fluk3d
Occasional Contributor

vlan routing problem

Hello I have setup a trunk to a cisco srw2048 and the trunk link works.

I can pass 802.1q traffic from one vlan to other however, I cannot get to the internet if using the interface of the procurve on the vlan.

I can get onto the internet if I change the gw of the client pc to the router on the same vlan. I attached my config - any help would be great.

All testing is being done from the client that is connected to the cisco switch where the trunk is configured between the procurve.
3 REPLIES
abdullah shboull
Frequent Advisor

Re: vlan routing problem

try to delete the command:
ip default-gateway 192.168.16.1
and test the result.
because its wrong to put tow default gateway, meanning the default route 0.0.0.0 0.0.0.0 192.168.13.1 is working like the ip default-gateway 192.168.16.1 , therefore the internet trafic go to the wrong gateway 192.168.16.1
but make sure that 192.168.13.1 is the correct gateway to the internet (the router interface).
kianwei
Advisor

Re: vlan routing problem

Please confirm your default route point to the correct next hop (router). Default gateway not require if ip routing is enable. ;p
abdullah shboull
Frequent Advisor

Re: vlan routing problem

please sign the point plz if we helped you in your issue