HPE Community
Switches, Hubs, and Modems
1753470 Members
5489 Online
108794 Solutions
New Discussion

Re: xrrp on two 3400cl that are meshed

 
Jason Steig
Occasional Contributor

‎07-08-2008 04:46 AM

‎07-08-2008 04:46 AM

xrrp on two 3400cl that are meshed

Will XRRP work on two meshed switches? If I have a normal XRRP configuration on two meshed switches, if one switch link fails on one of the switches down to the LAN will XRRP failover to the other link as it should? I don't think it will because the stack has made it one switch.
0 Kudos
1 REPLY 1
Mohieddin Kharnoub
Honored Contributor

‎07-08-2008 07:45 AM

‎07-08-2008 07:45 AM

Re: xrrp on two 3400cl that are meshed

Hi

If switch meshing (HP ProCurve L2 protocol) enabled on a switch, then routing can;t be enabled - L3.

However, you can still interconnect all your switches and enable spanning tree like MSTP in a full mesh topology and run XRRP.

Good Luck !!!
Science for Everyone
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.