- Community Home
- >
- Networking
- >
- Legacy
- >
- Switching and Routing
- >
- 3com 4200G 24port can't login to use recovery.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2011 08:53 PM
02-19-2011 08:53 PM
3com 4200G 24port can't login to use recovery.
Hi I just purchased a used 3com 4200G 24 port switch and as far as switching goes it works but I really would like to get into the webgui or just assign an ip so i can ssh or telnet in but I don't have the rj-45 to 9 pin console cable I used the pin out to try and make one but it did not work. Is there a way to reset back to factory defaults with out it? If not where can I get the console cable for it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2011 10:08 PM
02-19-2011 10:08 PM
Re: 3com 4200G 24port can't login to use recovery.
I followed the pin out exactly but I had the 9th pin on the serial side left over it said it went to shell but idk what that is.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2011 10:54 PM
02-21-2011 10:54 PM
Re: 3com 4200G 24port can't login to use recovery.
Does anyone know the part number for the rj-45 to 9 pin console cable?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2011 08:37 AM
02-24-2011 08:37 AM
Re: 3com 4200G 24port can't login to use recovery.
Hi,
They are the same as any other RJ45 - Serial Converter, like those used by Cisco etc. Pinout is as follows: