Switching and Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

Port address translation on JG732A

 
Highlighted
Occasional Collector

Port address translation on JG732A

Hi, on a Cisco PIX I had a config where the WAN port was 1xx.1x.253.10 and the LAN subnet was 1xx.1xx.68.0/24 - a public IP range.

I had PAT setup so that I could open and close ports for the LAN subnet. By default all incoming ports were closed. If I opened the RDP port then RDP could be used from the WAN to connect to all of the machines on the 68 subnet. Similarly if I opened the SSH port, from the WAN I could SSH to any machine on the 68 subnet.

How do I set this up on a MSR1003-8?

1 REPLY 1
Highlighted
HPE Pro

Re: Port address translation on JG732A

Hi,

Please use the below link and follow the guide to configure NAPT (PAT) on MSR1003-8 router.

https://www.manualshelf.com/manual/hp/hp-msr1003-8-ac-router/r2511-hp-msr-router-series-layer-3-ip-services-configuration-guidev5/page-8.html

 

I am an HPE Employee


Accept or Kudo