- Community Home
- >
- Networking
- >
- Legacy
- >
- Switching and Routing
- >
- VLAN Routing on Procurve 2848
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-01-2011 12:20 PM
11-01-2011 12:20 PM
VLAN Routing on Procurve 2848
I have a Procurve 2848 set at factory defaults. I need to set it up as an isolated lab switch that I can plug devices from multiple subnets into but those devices must be able to communicate with each other when necessary. How do I configure VLANs/Layer 3 options for this? I am afraid I am not very switch/router savvy.
Any assistance is greatly appreciated.
PG
- Tags:
- VLAN
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-02-2011 07:27 AM
11-02-2011 07:27 AM
Re: VLAN Routing on Procurve 2848
Hope this helps:
config t
ip routing
vlan 1
ip address 192.168.1.1 255.255.255.0
untagged 1-6
exit
vlan 2
ip address 192.168.2.1 255.255.255.0
untagged 7-12
exit
ip route 0.0.0.0 0.0.0.0 192.168.1.254
You can rinse and repeat for any additional VLANs. I might also suggest that you setup a seperate vlan for your outbound traffic and change the default route (0.0.0.0) as appropriate. The untagged command for each vlan is for the ports you want to hang those devices off of. If you need a link to another switch to extend the reach, you will need to setup a ports as 'tagged" to get those vlans and IP to another switch. On the other switch, you would only need to setup the vlan and the tagged/untagged ports, not the IP's.