configure 2910al switch ports for outside access??

[Tom Lyczko]

I'm new to HP ProCurve switches, I need to configure two ports on the switch to outside access with the ISP's IPs, gateway, DNS, etc. We have this configured on our other HP switches, not done by me though.

I have the two ports in an 'Outside' VLAN 50, they are untagged ports in the VLAN and 'No" in the default VLAN.

The other switch that does properly allow outside access has 'Trk1' on port 26, but this switch has no port 26...

What should I do to make these switch ports work as desired??

Thank you, Tom