Skip to ContentSkip to Footer
Start of content
- Community Home
- >
- Servers and Operating Systems
- >
- Operating System - Linux
- >
- System Administration
- >
- About SAN server
System Administration
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Forums
-
Blogs
- Alliances
- Around the Storage Block
- Behind the scenes @ Labs
- HPE Careers
- HPE Storage Tech Insiders
- Infrastructure Insights
- Inspiring Progress
- Internet of Things (IoT)
- My Learning Certification
- OEM Solutions
- Servers: The Right Compute
- Shifting to Software-Defined
- Telecom IQ
- Transforming IT
- Infrastructure Solutions German
- L’Avenir de l’IT
- IT e Trasformazione Digitale
- Enterprise Topics
- ИТ для нового стиля бизнеса
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-19-2010 08:55 AM
10-19-2010 08:55 AM
About SAN server
We have SAN CX300 which attached to the linux server , after re-boot these two servers , I use the below command and found the below result , I have already start Powerpath , navisphere , the qla logic card is also started ( known from server log ) , can advise how can I attach it again ?
#/sbin/powermt display dev=all
Device(s) not found.
#/sbin/powermt display dev=all
Device(s) not found.
1 REPLY
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-19-2010 09:31 AM
10-19-2010 09:31 AM
Re: About SAN server
you are probably better off searching for answers in an EMC forum but here is a place to start.
1) powermt is an EMC multipath solution, i believe there is a discover/scan option to this command ( read the user guide).. the luns just may need discovered again. if not..
2) switches zones properly ?
3) lun masking correct ?
4) fiber channel cabled properly.
you will need to either work your way forwards or backwards through this list..
1) powermt is an EMC multipath solution, i believe there is a discover/scan option to this command ( read the user guide).. the luns just may need discovered again. if not..
2) switches zones properly ?
3) lun masking correct ?
4) fiber channel cabled properly.
you will need to either work your way forwards or backwards through this list..
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2019 Hewlett Packard Enterprise Development LP