Community
System Administration
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

BMIC command Identify controller (0x11) is not giving proper slot number.

 
swamicse
swamicse
Occasional Contributor

‎09-04-2012 10:59 PM

‎09-04-2012 10:59 PM

BMIC command Identify controller (0x11) is not giving proper slot number.

Hi All,

 

In HPUX , I have written a c pgm using BMIC to get the output of Identify controller command(0x11) . In the output buffer I am getting wrong slot number for the controller.

 

After referring to the BMIC document i came to know that , slot number field for the Identify Controller command is not yet implemented for Integrity Server(IA 64).

 

Is there any other way to get the slot number using any method?

 

 

Thanks in advance.

0 Kudos
Reply
1 REPLY
Torsten.
Torsten.
Acclaimed Contributor

‎09-04-2012 11:07 PM - edited ‎09-04-2012 11:13 PM

‎09-04-2012 11:07 PM - edited ‎09-04-2012 11:13 PM

Re: BMIC command Identify controller (0x11) is not giving proper slot number.

I'm sure you now get answers about olrad and so on - why not continue your other thread?

 

http://h30499.www3.hp.com/t5/System-Administration/PCI-slot-no-in-HPUX/m-p/5792997

 


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.