Operating System - HP-UX
1748104 Members
4538 Online
108758 Solutions
New Discussion

Re: Change the LAN name on HP-UX 11iv3

 
SOLVED
Go to solution
Torsten.
Acclaimed Contributor

Re: Change the LAN name on HP-UX 11iv3

Why you cannot swap the cables from one card to the other?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
iazuarah
Advisor

Re: Change the LAN name on HP-UX 11iv3

Because one switch has fc cables and the other one utp...

 

In fact when i execute the # ioinit -f /tmp/lanswap , i don't receive some message, is correct ?. The lanics that i want to swap must be unconfigured ??

 

- swaplan file content:

 

1/0/2/1/1 lan9

 

Where 1/0/2/1/1 is the HW path for the lan2

 

Regards

Torsten.
Acclaimed Contributor

Re: Change the LAN name on HP-UX 11iv3

Should be

1/0/2/1/1 lan 9

(space between "lan" and "9")

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
iazuarah
Advisor

Re: Change the LAN name on HP-UX 11iv3

mm, i think that something is missing. When i execute the ioinit command don't receive some message. And when i check the routes and hw lanic status. I has the same hw paths for the name lanics.

 

Hardware Station        Crd Hdw   Net-Interface  NM  MAC       HP-DLPI DLPI
Path     Address        In# State NamePPA        ID  Type      Support Mjr#
1/0/1/1/0/4/0 0x001A4B9D44DE 0   UP    lan0 snap0     1   ETHER     Yes     119
1/0/2/1/0 0x001A4B0604AC 1   UP    lan1 snap1     2   ETHER     Yes     119
1/0/2/1/1 0x001A4B0604AD 2   UP    lan2 snap2     3   ETHER     Yes     119  --> this must be lan3
1/0/12/1/0 0x001A4B06DA96 3   UP    lan3 snap3     4   ETHER     Yes     119 ---> this must be lan2
1/0/12/1/1 0x001A4B06DA97 4   UP    lan4 snap4     5   ETHER     Yes     119
LinkAgg0 0x000000000000 900 DOWN  lan900 snap900 7   ETHER     Yes     119
LinkAgg1 0x000000000000 901 DOWN  lan901 snap901 8   ETHER     Yes     119
LinkAgg2 0x000000000000 902 DOWN  lan902 snap902 9   ETHER     Yes     119
LinkAgg3 0x000000000000 903 DOWN  lan903 snap903 10  ETHER     Yes     119
LinkAgg4 0x000000000000 904 DOWN  lan904 snap904 11  ETHER     Yes     119

 

Some idea ??

 

Regards