HPE Community
Operating System - Linux
1753359 Members
4886 Online
108792 Solutions
New Discussion

Command for virtual config

 
Robert S. White
Advisor

‎10-27-2010 11:53 AM

‎10-27-2010 11:53 AM

Command for virtual config

I support DL380 and DL580 (G3-G7)hosts running Red Hat Enterprise 3, 4, and 5.

Would like to know which physical disks make up the hpa logical drive.
The hpacucli command shows pd and the logical disk, but I can not determine if all the physical disks are used in the logical drive.
Is this a case where the answer is always "All of them"?
Computers are just external storage for my brain.
0 Kudos
Reply
1 REPLY 1
macosta
Trusted Contributor

‎10-27-2010 02:58 PM

‎10-27-2010 02:58 PM

Re: Command for virtual config

Can you post the output of "pd all show" from hpacucli? Perhaps also the output of "ld all show".

I seem to recall that unused disks show up as "unassigned" or similar.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.