cancel
Showing results for 
Search instead for 
Did you mean: 

Command for virtual config

 

Command for virtual config

I support DL380 and DL580 (G3-G7)hosts running Red Hat Enterprise 3, 4, and 5.

Would like to know which physical disks make up the hpa logical drive.
The hpacucli command shows pd and the logical disk, but I can not determine if all the physical disks are used in the logical drive.
Is this a case where the answer is always "All of them"?
Computers are just external storage for my brain.
1 REPLY
macosta
Trusted Contributor

Re: Command for virtual config

Can you post the output of "pd all show" from hpacucli? Perhaps also the output of "ld all show".

I seem to recall that unused disks show up as "unassigned" or similar.