HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Configure HP RAID SA interfaces fails

 
Santhosh_Mani
Occasional Contributor

Configure HP RAID SA interfaces fails

Hi all

When i start reboot my server the time of bootup it gives  fail states related to HP RAID SA

Configure HP RAID SA interfaces...............FAIL*

 

6 REPLIES
Santhosh_Mani
Occasional Contributor

Re: Configure HP RAID SA interfaces fails

 
Torsten.
Acclaimed Contributor

Re: Configure HP RAID SA interfaces fails

You should at least tell the server model, controller model and your OS.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Santhosh_Mani
Occasional Contributor

Re: Configure HP RAID SA interfaces fails

Hi Torsten,

This is machine details which i have used HP-UX B.11.31 ia64 hp server rx2660.

Torsten.
Acclaimed Contributor

Re: Configure HP RAID SA interfaces fails

Oooookay.

 

Does the server boot up?

What does the rc.log file say (search for the RAID entry)?

Run "ioscan" to get the ciss device for the controller and use "sautil" "saconfig" for more details, e.g.

 

sautil /dev/ciss0


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Santhosh_Mani
Occasional Contributor

Re: Configure HP RAID SA interfaces fails

Hi Torsten,

Yeah, server boot up is normal.I have tried with the sautil command its showing for the one disk statu like (USING INTERIM RECOVERY MOD) and capacity status N/A.

Torsten.
Acclaimed Contributor

Re: Configure HP RAID SA interfaces fails

this is a bad disk.

you need to show us the output ...

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!