HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring SSH

 
SOLVED
Go to solution
Fern H2O
Frequent Advisor

Configuring SSH

Hello All,

I'm trying to configure OpenSSL on my server. RP7420 (11.11). I installed this version - OpenSSL_A.00.09.07m.041_HP-UX_B.11.11_32_64.depot

After installing I can't seen to find the executbale to run ssh. I've looked at where the files should be but none exist. For example, these do not exist

/opt/ssh/sbin/sshd
/sbin/init.d/secsh
/usr/sbin/sshd

Output for Swlist is:

swlist | grep -i open
OpenSSL A.00.09.07m.041 Secure Network Communications Protocol

Can anyone tell me what's going on???
3 REPLIES
Patrick Wallek
Honored Contributor
Solution

Re: Configuring SSH

You installed OpenSSL. You will NOT find the SSH binaries with OpenSSL.

You really wanted OpenSSH.

Go download that and install it.

You can get HP's port of SSH here:

http://h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=T1471AA
Fern H2O
Frequent Advisor

Re: Configuring SSH

Thanks Patrick!! You were totally right...

One final question... Was it necessary for me to install OpenSSL as well as OpenSSH?? And if not, what is OpenSSL used for then??

Thanks again!
Fern H2O
Frequent Advisor

Re: Configuring SSH

Closed