HPE Community
Operating System - HP-UX
1751915 Members
5019 Online
108783 Solutions
New Discussion юеВ

Re: Connecting a HVD10 to a K380 running 10.20

 
Marc Ahrendt
Super Advisor

тАО04-23-2009 07:47 AM

тАО04-23-2009 07:47 AM

Connecting a HVD10 to a K380 running 10.20

The issue I am having is that the 4 "HP 73.4GATLAS10K3_73_SCA" drives in the HVD10 show up in "ioscan -fn" as unclaimed and unknown ...yet the kernel has the sdisk driver. The 2 28696A HBAs used to connect to teh HVD10 show up claimed and use the scsi3 driver. I am at the point where I think it may be a patch issue, and my system has the HW bundle from 03/2000 and the general bundle from 12/2001. Any ideas on how to get this 4 disks to be claimed by the sdisk driver?
hola
0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО04-23-2009 08:33 AM

тАО04-23-2009 08:33 AM

Re: Connecting a HVD10 to a K380 running 10.20

Hm, must be a sort of patch problem, since HVD SCSI disk should bnormally work with this server. I can't remember if the HVD10 was supported with 10.20 ...

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Marc Ahrendt
Super Advisor

тАО04-25-2009 02:50 PM

тАО04-25-2009 02:50 PM

Re: Connecting a HVD10 to a K380 running 10.20

I found the solution after checking several past entries in the ITRC forums. The solution was to include the "disc3" driver into the kernel. Below is the link that provided me the answer:

http://forums13.itrc.hp.com/service/forums/questionanswer.do?admit=109447627+1240699603568+28353475&threadId=26981
hola
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.