DLT80e for Kclass

[Raymond Sit]

Hi

I just buy the SureStore DLT80e for the Kclass with HPUX10.20

Since the DLT80e supprt LVD/SE, so i connect it to the 28655A HP-PB SCSI adapter.

ext_bus 1 10/4/8 scsi1 CLAIMED INTERFACE HP 28655A - SE SCSI ID=7

The system auto detect the driver and the ioscan -fnC tape:

tape 1 10/4/8.1.0 tape2 CLAIMED DEVICE QUANTUM DLT8000
/dev/diag/rmt/c1t1d0 /dev/rmt/c1t1d0BEST
/dev/rmt/1m /dev/rmt/c1t1d0BESTb
/dev/rmt/1mb /dev/rmt/c1t1d0BESTn
/dev/rmt/1mn /dev/rmt/c1t1d0BESTnb

However i can't use the drive..
# mt -t /dev/rmt/1mn status
/dev/rmt/1mn: I/O error
# mt -t /dev/rmt/1mn rew
/dev/rmt/1mn: I/O error
# tar cvf /dev/rmt/1mn /etc
tar: cannot open /dev/rmt/1mn


Thanks

[Michael Tully]

Do you have the latest patches SCSI installed?
What firmware do you have loaded?
When you ran the mt -t commands, was there a tape loaded?
If so, hHave you tried some different tapes?

Is the device correctly terminated?

Regards
Michael
"When I have trouble spelling, it's called fat finger syndrome"

[Animesh Chakraborty]

Hi,
It will not work on HPPB cards.
If you have HSC scsi card, then connect it or you can conncet it on core i/o card.
but the performance will be slower.

[Raymond Sit]

Hi,

Michael, I have install the latest patch

PHKL_22855 B.10.00.00.AA stape and tape2 cumulative patch

And i have load different type tape, the problem are still remain.

Animesh, I heard people say HPPB not support DLT. But the the DLT80e only support LVD/SE. The kclass server have

ext_bus 0 10/0 c720 CLAIMED INTERFACE GSC built-in Fast/Wide SCSI Interface
ext_bus 1 10/4/8 scsi1 CLAIMED INTERFACE HP 28655A - SE SCSI ID=7
ext_bus 2 10/4/12 scsi3 CLAIMED INTERFACE HP 28696A - Wide SCSI ID=7
ext_bus 3 10/8 c720 CLAIMED INTERFACE GSC add-on Fast/Wide SCSI Interface
ext_bus 4 10/12/5 c720 CLAIMED INTERFACE Built-in SCSI

I have try to connect the DLT80e to those interface, but the server can't scan the device.

[Animesh Chakraborty]

Hi Raymaond,
You can buy LVD to HVD converter.

See details here
http://www.paralan.com/mh16.html

[Raymond Sit]

Hi animesh,

Did you recommend to put the conventor between the 28655A HP-PB SE SCSI adapter and the DLT80e?

Do you know how much it cost?

thanks

[Rajesh G. Ghone]

Hi Raymond,

Did you tried giving
#insf -e command sometimes the you need to give this command.
Try giving this command & check.

Regards,
Rajesh G.