Hi,
This is explained in the mentioned link.
How to Set the GSP Terminal Type:
Access the GSP through the lan console, the remote-modem port, or a physically connected terminal.
Use the CA command at the GSP prompt to modify the console attributes:
GSP> ca
Answer ├в y├в (yes) to indicate that you want to change the console port settings:
Do you want to modify the Local Console Serial Port settings? (Y/[N]) y
Answer ├в n├в (no) to the questions about modifying the ├в Serial Port bit rate├в and the ├в Current Flow Control├в
Current Local Console Serial Port bit rate: 9600 bits/s
Do you want to modify it? (Y/[N]) nCurrent Flow Control: SoftwareDo you want to modify it? (Y/[N]) nIndicate which terminal type you want to use, then answer ├в y├в (yes) to confirm your change:
Enter Terminal Type ([Vt100] / Hpterm):
New Terminal Type: hpterm
Confirm? (Y/[N]): y
-> Terminal Type will be updated.
Answer n (no) to the question about updating the ├в Remote Console Serial Port Modem settings├в :
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N]) n
You will see a message indicating the command execution will take a few seconds and then a message indicating that your settings have been updated.
Best wishes,
Ganesh.
