cancel
Showing results for 
Search instead for 
Did you mean: 

EMS alerts setting.

sandyunix
Occasional Advisor

EMS alerts setting.

Hi Techies,

I have a problem with hp-ux 11.23 server. The server is connected with 2 power supplies and when both of them are fine, we have been continuously receiving EMS alerts about a faulty power supply. We suspect that the server has been looking for three supplies and that is the reason, these are generated. Can someone please advise me how i can prevent these EMS alerts from generating.

Thanks in advance
5 REPLIES
Jose Mosquera
Honored Contributor

Re: EMS alerts setting.

EMS notify you for installed power supplies. Pls check that power cords have well plugged into their sockets. EMS also indicates you a power supply identificator where failure appear (0, 1 or 2), go for it to isolate the issue. In last option please call to replace damaged part.

Rgds.
Jose Mosquera
Honored Contributor

Re: EMS alerts setting.

By the way, please check the power cords health, do not doubt to replace them.
Alzhy
Honored Contributor

Re: EMS alerts setting.

How are you receiving EMS alerts on your PS issue? Via ISEE/SIM or some custom email alerting that feeds off syslog?

Hakuna Matata.
sandyunix
Occasional Advisor

Re: EMS alerts setting.

I am recieving EMS alerts in the syslog. Also i'd logged a Hardware call. The CE checked the power supplies and informed us that there is no failure in any of the power supplies.
Alzhy
Honored Contributor

Re: EMS alerts setting.

it is likely you need to update your HPDIAGS software.

You can also check the GSP logs IF there is indeed a report of power supply issues.

If there is - then point this out to HP... they should uncover what is wrong.
Hakuna Matata.