FC tape drive configuration on Redhat AS

[Nappy_1]

i have 4 FC tape drives (LTO4) connected to redhat AS 4 through a brocade switch
the server is using 2 qlogic ql2462 hba cards

the sansurfer tool is able to see the 4 devices but don't know where is the device files related to them.

so where are the device file? if they don't exist how to do to create them?
how can i test the tape drives to be sure they are well configured?

[Asif Sharif]

Hi Nappy,

please see the below web links.
http://www.redhat.com/docs/manuals/enterprise/RHEL-4-Manual/release-notes/as-s390/RELEASE-NOTES-U3-s390-en.html
http://forums11.itrc.hp.com/service/forums/questionanswer.do?admit=109447626+1213181650107+28353475&threadId=1136273

Regards,
Asif Sharif

[Ivan Ferreira · Accepted solution]

>>> so where are the device file? if they don't exist how to do to create them?

Device files should be created after detected. You should see /dev/stX /dev/nstX.

Try with hp_rescan -a. You should install the support pack if this is a proliant server.

[Nappy_1]

Hi Ivan
this is an IBM server

[Nappy_1]

lsscsi command shows old scsi tape devices but don't show the new FC tape devices

is it the normal behaivor of lsscsi? is there another command that can show FC devices?

[Ivan Ferreira]

Please see:

http://www.redbooks.ibm.com/redpieces/pdfs/sg246268.pdf