HPE Community
Operating System - HP-UX
1753738 Members
4438 Online
108799 Solutions
New Discussion

Flow Control

 
ManojK_1
Valued Contributor

‎12-07-2008 06:52 AM

‎12-07-2008 06:52 AM

Flow Control

How can i check whether the flow control is on for lan1 in HP unix.

If it is off, how can i make it on.

Manoj K
Thanks and Regards,
Manoj K
0 Kudos
Reply
1 REPLY 1
Johnson Punniyalingam
Honored Contributor

‎12-07-2008 09:33 AM

‎12-07-2008 09:33 AM

Re: Flow Control

lanadmin -X or SAM

The speed configuration of the 1000Base-T card can be 10, 100, or 1000Mbps and is determined by the speed setting of the hub or switch port to
which the card is connected. The card automatically senses this speed. The card only runs at one speed at a time. To verify the speed selection, run
lanadmin -x ppa# or lanadmin -x nmid
Problems are common to all, but attitude makes the difference
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.