Showing results for 
Search instead for 
Did you mean: 

Flow Control

Valued Contributor

Flow Control

How can i check whether the flow control is on for lan1 in HP unix.

If it is off, how can i make it on.

Manoj K
Thanks and Regards,
Manoj K
Johnson Punniyalingam
Honored Contributor

Re: Flow Control

lanadmin -X or SAM

The speed configuration of the 1000Base-T card can be 10, 100, or 1000Mbps and is determined by the speed setting of the hub or switch port to
which the card is connected. The card automatically senses this speed. The card only runs at one speed at a time. To verify the speed selection, run
lanadmin -x ppa# or lanadmin -x nmid
Problems are common to all, but attitude makes the difference