Graphics Resolution Configuration for Esla Gloria Synergy

[Kris Smith]

I have a DS10 running Tru64 UNIX 4.0F with 3 Elsa Gloria Synergy cards, also known as PowerStorm 4D10T. The driver is comet and I have no documnetation for either the driver or the card. How to I change to a resolution of 1280x1024 with a refresh rate of 60Hz ?

[Mohamed K Ahmed]

If you are using DEC Windows, you can set it by editing the Xresources file

HTH
Mohamed

[Michael Schulte zur Sur]

I think, this belongs here. ;-)

The OpenGL (Open3D for Tru64) driver and subset were located on Associated Products Volume 2 - OSFPAT00002210440. Once this was installed and the system was rebooted, I was able to modify the Xserver.conf file as described by the man pages. I still don't have the Documentation, but the cards are running at the resolution and scan rate that I desire. Thanks to Mohamed K Ahmed, whose reply was in line with my end solution

[Mohamed K Ahmed]

That's what I meant, Xserver.conf file.

[Ralf Puchner]

hopefully you created a new /etc/dt/config/Xservers file instead of modifing the original one in /usr/dt/config. The procedure is described in detail within the header of the Xservers file.