HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

HP C3700 system panic

 
BruceLiu
Occasional Contributor

HP C3700 system panic

Hi,

My C3700 workstaion panic with the following message, and I failed when I try to boot with "hpux -lm" or "hpux -is" or "hpux -lq" or "hpux -lm (;0)/stand/vmunix.prev", what's wrong ?

Main Menu: Enter command > boot
Interact with IPL (Y, N, Q)?> y

Booting...
Boot IO Dependent Code (IODC) revision 0


HARD Booted.

ISL Revision A.00.43 Apr 12, 2000

ISL> boot -is

Not an isl command or utility.

Not an isl command or utility.

ISL> hpux -is

Boot
: disk(10/0/15/1.6.0.0.0.0.0;0)/stand/vmunix
11698176 + 1961984 + 4794856 start 0x1fcae8
gate64: sysvec_vaddr = 0xc0002000 for 2 pages
NOTICE: autofs_link(): File system was registered at index 3.
NOTICE: cachefs_link(): File system was registered at index 5.
NOTICE: nfs3_link(): File system was registered at index 6.

System Console is on the Built-In Serial Interface
Logical volume 64, 0x3 configured as ROOT
Logical volume 64, 0x2 configured as SWAP
Logical volume 64, 0x2 configured as DUMP
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 64, minor is 0x2; start = 0, size = 8388608
Starting the STREAMS daemons-phase 1

linkstamp: Wed Oct 28 09:45:38 EAT 2009
_release_version: @(#) $Revision: vmunix: vw: -proj selectors: C$
panic: all VFS_MOUNTROOTs failed: NEED DRIVERS ?????

PC-Offset Stack Trace (read across, top


Stored message buffer up to panic:
gate64: sysvec_vaddr = 0xc0002000 for 2 pages
NOTICE: autofs_link(): File system was registered at index 3.
NOTICE: cachefs_link(): File system was registered at index 5.
NOTICE: nfs3_link(): File system was registered at index 6.
10 sba
10/0 lba
10/0/12/0 btlan
10/0/13/0 audio
10/0/14/0 side
10/0/14/0.0 tgt
10/0/14/0.0.0 sdisk
10/0/14/0.7 tgt
10/0/14/0.7.0 sctl
10/0/14/1 superio
10/0/14/1/1 asio0
10/0/14/1/2 asio0
10/0/14/1/3 SCentIf
10/0/14/2 hcd
10/0/14/2.1 hub
10/0/15/0 c720
10/0/15/0.7 tgt
10/0/15/0.7.0 sctl
10/0/15/1 c720
10/0/15/1.6 tgt
10/0/15/1.6.0 sdisk
10/0/15/1.7 tgt
10/0/15/1.7.0 sctl
10/1 lba
10/4 lba
10/6 lba
Variable size pages used to map 1000 graf pages at fffffffffb000000
10/6/2/0 graph3
32 processor
49 memory
btlan: Initializing 10/100BASE-TX card at 10/0/12/0....

System Console is on the Built-In Serial Interface
Logical volume 64, 0x3 configured as ROOT
Logical volume 64, 0x2 configured as SWAP
Logical volume 64, 0x2 configured as DUMP
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 64, minor is 0x2; start = 0, size = 8388608
Dump device table: (start & size given in 1-Kbyte blocks)
entry 0000000000000000 - major is 31, minor is 0x36000; start = 330592,4
Starting the STREAMS daemons-phase 1

System Panic:

linkstamp: Wed Oct 28 09:45:38 EAT 2009
_release_version: @(#) $Revision: vmunix: vw: -proj selectors: C$
panic: all VFS_MOUNTROOTs failed: NEED DRIVERS ?????

PC-Offset Stack Trace (read across, top of stack is 1st):
0x0020f3d8 0x00307a28 0x0036fe5c
0x004baa2c 0x00370910 0x00177c64
0x001fd0e4
End Of Stack

sync'ing disks (0 buffers to flush): (0 buffers to flush):
0 buffers not flushed
0 buffers still dirty



*** A system crash has occurred. (See the above messages for details.)
*** The system is now preparing to dump physical memory to disk, for use
*** in debugging the crash.





*** The dump will be a SELECTIVE dump: 115 of 1024 megabytes.
*** To change this dump type, press any key within 10 seconds.


Can somebody give a clue.

With thanks in advance,

Bruce
1 REPLY
Johan Guldmyr
Honored Contributor

Re: HP C3700 system panic