cancel
Showing results for 
Search instead for 
Did you mean: 

HPUX11iv3

 
SamirShrestha
Frequent Advisor

HPUX11iv3

I've new fresh two unit rx3600 servers with P400 raid controller to configure raid 1 with 2x300GB hard drives. I would like to connect HP Storage workd modular smart array 60 with dual i/o modlues,8x300GB drives. What will be best solution to configure and setup two servers with one storage on high level of redundancy point of failure.
3 REPLIES
Hakki Aydin Ucar
Honored Contributor

Re: HPUX11iv3

in generally I can say raid5 is good choice.
SamirShrestha
Frequent Advisor

Re: HPUX11iv3

I would like to configure HP service guard cluster with two nodes. in such hardware environment.Can any one help to provide step by step commands to configure HP service guard cluster.
Denver Osborn
Honored Contributor

Re: HPUX11iv3

I'd recommend starting with the user guide. If you run into any problems after reviewing the user guide, search the forums or post your specific question then. Other than an HP training course, the user guide should be your 1st stop.

http://h20000.www2.hp.com/bizsupport/TechSupport/CoreRedirect.jsp?redirectReason=DocIndexPDF&prodSeriesId=4162060&targetPage=http%3A%2F%2Fbizsupport2.austin.hp.com%2Fbc%2Fdocs%2Fsupport%2FSupportManual%2Fc02437444%2Fc02437444.pdf


Additional user guides, rel notes and white papers are here:

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?lang=en&cc=us&taskId=101&prodClassId=10008&contentType=SupportManual&docIndexId=64255&prodTypeId=18964&prodSeriesId=4162060

Have fun!
-denver