System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

How to change controller target and disk number in hpux ?

Narendra Thapa
Frequent Advisor

How to change controller target and disk number in hpux ?

Hi,
I have shared disk attached to two of my hp machines but I see different controller numbers for both the machines. Is there any way that I can change the controller number of the disks so that I can see the same controller + target + disk number from both machines.

***********************************************
My machines SNIP:

Node1:

c7t0d0 auto:cdsdisk - - online
c7t0d1 auto:cdsdisk - (dg1) online
c7t0d2 auto:cdsdisk - (dg1) online
c7t0d3 auto:cdsdisk - (dg2) online
c7t0d4 auto:LVM - - LVM
c7t0d5 auto:LVM - - LVM


Node 2

c5t0d1 auto:cdsdisk - (dg1) online
c5t0d2 auto:cdsdisk - (dg1) online
c5t0d3 auto:cdsdisk - (dg2) online
c5t0d4 auto:LVM - - LVM
c5t0d5 auto:LVM - - LVM

***********************************************

Now I want to make both the controller 5 or 7 so that I can see the same controller/target/disk in both the nodes.

"Study as if you were going to live forever; live as if you were going to die tomorrow."
4 REPLIES
sen_ux
Valued Contributor

Re: How to change controller target and disk number in hpux ?

Hi,

Please check the below forum and the procedure attached to it.

SEN
sen_ux
Valued Contributor

Re: How to change controller target and disk number in hpux ?

Jozef_Novak
Respected Contributor

Re: How to change controller target and disk number in hpux ?

R.K. #
Honored Contributor