How to check the Physical CPU.

[lafargeadmin]

Can anyone tell me, are there any commands to check the processsor info. Whether it's dual core or single.

I got the output of;
#echo "selclass qualifier cpu;info;wait;infolog" | cstm > /tmp/cpuinfo

shows;

grep "Slot Number" /tmp/cpuinfo
Slot Number: 0 Software Capability: 0x100000f1
Slot Number: 0 Software Capability: 0x100000f1
Slot Number: 0 Software Capability: 0x100000f1
Slot Number: 0 Software Capability: 0x100000f1

I can see 4 CPU sitting on the same slot. What does this mean?

[Robert-Jan Goossens_1 · Accepted solution]

Hi,

Have a look at this thread.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1096534

Regards,
Robert-Jan

[Torsten.]

Hi,

if you have an Integrity server, at this time only the montecito is a dual core CPU, see

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1089669

In case of a PA-RISC system, all PA-8800 and PA-8900 CPUs are dual core.

[lafargeadmin]

Hi Robert and torsten,

Thanks a lot.

Both forum really helps me.

[Gary Cantwell]

Hi There,

Please take a moment to assign points to those who have taken the time to assist you. Here's how:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Thanks,

Gary

[Jollyjet]

Hi,


open sam and click on performance monitors and click on system properties if its dual core you will be getting the Active output greater than total Output.

[Alpa Shah]

Does PA-RISC 8800 or 8900 processors support Hyper threading technology?
If yes, is there a command to verify?

[lafargeadmin]

Thanks for all. I got it done

[Dennis Handly]

>Alpa: Does PA-RISC 8800 or 8900 processors support Hyper threading technology?

No, those were just dual core.