Operating System - HP-UX
1748255 Members
3856 Online
108760 Solutions
New Discussion юеВ

Re: How to convert agile DSF to legacy DSF and vice versa in HPUX 11.31

 
Avinash20
Honored Contributor

Re: How to convert agile DSF to legacy DSF and vice versa in HPUX 11.31

Also please assign points to your thread if you find your answers
http://forums13.itrc.hp.com/service/forums/helptips.do?#33

No point for this please
"Light travels faster than sound. That's why some people appear bright until you hear them speak."
HejALL
Occasional Contributor

Re: How to convert agile DSF to legacy DSF and vice versa in HPUX 11.31

Try #ioscan -L
sksarangi
New Member

Re: How to convert agile DSF to legacy DSF and vice versa in HPUX 11.31

I tried setting the SPC2 bit for the device. But that did not help either.
"symmask -sid 072 set hba_flags on SPC2 -enable -wwn 5001438001321214 -dir 15C -p 1"
I am sure there is something wrong with symm configuration. if you notice the cmd output of "ioscan -m hwpath" ( attached file before), we can see "Legacy H/W Path" for few devices and also it contains something like "0/4/1/0.1.0.255.0.7.1", the no "255" looks incorrect.
Please advice any solution.
Thanks,
-Santosh.

Re: How to convert agile DSF to legacy DSF and vice versa in HPUX 11.31

so EMC usually have a host connectivity guide per OS. Have you got a copy of this - no doubt it lists all the requirements for running 11iv3?

Why not just ask EMC to check your configuration? They're usually pretrty good at this sort of request.

HTH

Duncan

I am an HPE Employee
Accept or Kudo