cancel
Showing results for 
Search instead for 
Did you mean: 

How to reset stm's log

 
SOLVED
Go to solution
Carme Torca
Super Advisor

How to reset stm's log

Hi,

I have a lot of messages in stm, and in the syslog it says:

Apr 22 14:02:23 hp9ges02 vmunix: DIAGNOSTIC SYSTEM WARNING:
Apr 22 14:02:23 hp9ges02 vmunix: The diagnostic logging facility is no longer receiving excessive
Apr 22 14:02:23 hp9ges02 vmunix: errors from the I/O subsystem. 6 I/O error entries were lost.
Apr 22 14:02:53 hp9ges02 vmunix: The diagnostic logging facility has started receiving excessive
Apr 22 14:02:53 hp9ges02 vmunix: errors from the I/O subsystem. I/O error entries will be lost
Apr 22 14:02:53 hp9ges02 vmunix: until the cause of the excessive I/O logging is corrected.
Apr 22 14:02:53 hp9ges02 vmunix: DIAGNOSTIC SYSTEM WARNING:
Apr 22 14:02:53 hp9ges02 vmunix: If the diaglogd daemon is not active, use the Daemon Startup command
Apr 22 14:02:53 hp9ges02 vmunix: in stm to start it.
Apr 22 14:02:53 hp9ges02 vmunix: If the diaglogd daemon is active, use the logtool utility in stm
Apr 22 14:02:53 hp9ges02 vmunix: to determine which I/O subsystem is logging excessive errors.


Is there any way to reset de stm's log?

Thanks a lot of!
Carmen.
Users are not too bad ;-)
1 REPLY
R.O.
Esteemed Contributor
Solution

Re: How to reset stm's log

Hi,

Watch this thread:

http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=958767


Regards,
"When you look into an abyss, the abyss also looks into you"