Operating System - HP-UX
1748201 Members
3150 Online
108759 Solutions
New Discussion юеВ

Re: How to use iso9600 image file on HP-UX 11i

 
Zuojian
Occasional Contributor

How to use iso9600 image file on HP-UX 11i

How to use iso9600 image file(.iso file) on HP-UX 11i,thanks
5 REPLIES 5
Kent Ostby
Honored Contributor

Re: How to use iso9600 image file on HP-UX 11i

This thread discusses how to do it on a 10.20 system. Not sure if you would use the same steps, but its a starting point:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=104236
"Well, actually, she is a rocket scientist" -- Steve Martin in "Roxanne"
H.Merijn Brand (procura
Honored Contributor

Re: How to use iso9600 image file on HP-UX 11i

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=938988

is that what you want? I mean, do you have the same question?
Your question is too vague for me

Enjoy, Have FUN! H.Merijn
Enjoy, Have FUN! H.Merijn
Zuojian
Occasional Contributor

Re: How to use iso9600 image file on HP-UX 11i

I mean,I have a ISO file├в ├в software.iso,how to mount on mount-point /testdir ?
Thanks
H.Merijn Brand (procura
Honored Contributor

Re: How to use iso9600 image file on HP-UX 11i

You can't (yet) on HP-UX.
Sorry.

Burn is on CD and *then* you can mount.
HP-UX's mount command only supports devices, not files, and the loopback device cannot be used

Enjoy, Have FUN! H.Merijn
Enjoy, Have FUN! H.Merijn
Alzhy
Honored Contributor

Re: How to use iso9600 image file on HP-UX 11i

If you're used to loopback filesystems that support isofs (i.e. on Linux and Solaris), then you're out of luck. I've been asking this question (and I think I may have submitted an RFE/RFC) for about 3 years now.

Your best bet is just mount on Linux/Solaris and NFS share to HP-UX.
Hakuna Matata.