HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

HyperThreading ON problem

 

HyperThreading ON problem

Dear All,

I am facing the problem in hyperthreading. I run the below commands in my server.

#kctune lcpu_attr
Tunable Value Expression Changes
lcpu_attr 0 Default Auto
# kctune lcpu_attr=1
ERROR: This system does not support Hyperthreading, or Hyperthreading
has been disabled on this system (see setboot(1M)). Value of
tunable 'lcpu_attr' cannot be changed.

After this error i run below cmd to enable HT.

# setboot -m on
setboot: Hyperthreading settings cannot be changed while running on a vPars system.

Still HT is in off only..

Can any one help me..

2 REPLIES
Torsten.
Acclaimed Contributor

Re: HyperThreading ON problem

It is a HP-UX system, but details, please?

Is it running vPars?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Bill Hassell
Honored Contributor

Re: HyperThreading ON problem

A lot of missing info...HP-UX 11.23? or 11.31?

This manual will be helpful, chapter 9, starting on page 266:

https://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=4146186&docId=emr_na-c01942403&docLocale=en_US

 



Bill Hassell, sysadmin