- Community Home
- >
- Servers and Operating Systems
- >
- Operating System - HP-UX
- >
- System Administration
- >
- Ignite keeps disabling network connection
System Administration
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Categories
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Ignite keeps disabling network connection
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-23-2009 05:48 PM
09-23-2009 05:48 PM
Ignite keeps disabling network connection
Ignite keeps disabling network connection
Hi everyone,
We are trying to restore an imagine from the Ignite Server (version C.7.5.142), but before we can do anything (just starts the GUI)the network card keeps being disabled. We had to call the network person in to re-enable the card many times. Ignite GUI fails to respond at the same place, we hadn't even chosen an image yet. At the point of failure we had just entered the name of the host and an IP address. The ethernet port is on the core IO card of an RX7620, the switch ports are configured to autonegotiate. This happens on a few switch ports we've tried.
Any ideas why?
We are trying to restore an imagine from the Ignite Server (version C.7.5.142), but before we can do anything (just starts the GUI)the network card keeps being disabled. We had to call the network person in to re-enable the card many times. Ignite GUI fails to respond at the same place, we hadn't even chosen an image yet. At the point of failure we had just entered the name of the host and an IP address. The ethernet port is on the core IO card of an RX7620, the switch ports are configured to autonegotiate. This happens on a few switch ports we've tried.
Any ideas why?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2018 Hewlett Packard Enterprise Development LP