1752660 Members
5764 Online
108788 Solutions
New Discussion юеВ

Installing Diagnostics

 
SOLVED
Go to solution
Jennifer Chiarelli
Regular Advisor

Installing Diagnostics

I am getting the following email message on a J2240 which I recently installed HP-UX 11.

WARNING: POTENTIAL SYSTEM PROBLEM - For Series 700 Machines

System Diagnostics & Error Logging programs have NOT been
installed on your system. Without these tools installed,
information that could help prevent a system or peripheral failure
will be lost. In addition, if a failure occurs, HP will not have
the tools or data to diagnose the cause of the problem in a timely
manner. This MAY CAUSE INCREASED DOWNTIME and possible future
failures. HP strongly suggests that you load these tools, which
are provided on the Support Media included with your installation
or update software.

I have found Diagnostics on the HP-UX 11.0 Support Plus CD. But swinstall will not install it. I ran swreg -l depot /cdrom but it does not help. How should I go about installing Diagnostics?
It's a binary world!
7 REPLIES 7
Kofi ARTHIABAH
Honored Contributor

Re: Installing Diagnostics

Could you please post the error messages you are getting - also post the swinstall command that you are trying to use.
nothing wrong with me that a few lines of code cannot fix!
Antoanetta Naghiu
Esteemed Contributor

Re: Installing Diagnostics

You have to go one level deeper.
If you are using HP-UX Support Plus, the depot is not simple /cdrom is /cdrom/DIAGNOSTICS/B.11.00
There are some readme files as well.
For general patches, access /cdrom/XSWGR1100
Rick Garland
Honored Contributor
Solution

Re: Installing Diagnostics

mount the cd, start swinstall.
You will need the full path to where the DIAGS are on the CD.

Also, for 11.00, patch PHKL_18543 is required. I believe a total of 7 patches are required when the dependencies are worked out.

Installing DIAGS on 11.00 does not require a reboot but patch installation does.
James R. Ferguson
Acclaimed Contributor

Re: Installing Diagnostics

Lanny:

Specify the source as:

/cdrom/DIAGNOSTICS/B.11.00

and be sure to specify the reinstall option as true.

...JRF...
Brian M. Fisher
Honored Contributor

Re: Installing Diagnostics

When you select your Depot Source select /cdrom/DIAGNOSTICS/B.11.00

Brian
<*(((>< er
Perception IS Reality
Rick Garland
Honored Contributor

Re: Installing Diagnostics

NOTE: Put the patches on before installing DIAGS
Jennifer Chiarelli
Regular Advisor

Re: Installing Diagnostics

Thanks everyone! I was using swinstall and then defining the source as /cdrom/DIAGNOSTICS. I'll try defining it further.
It's a binary world!