Installing HP-UX 11.0 failed on rp3410

[Zhu Que]

I try to install HP-UX 11.0 on one rp3410 station, but encouter a failure as below during its booting.

Could someone give some suggestion?

----------------------------------------------
Main Menu: Enter command or menu > BO ide.0
Interact with IPL (Y, N, or Cancel)?> N

Booting...
Boot IO Dependent Code (IODC) revision 0


HARD Booted.

ISL Revision A.00.38 OCT 26, 1994

ISL booting hpux (;0):INSTALL

Boot
: disk(0/0/2/0.0.0.0.0.0.0;0):WINSTALL
8790032 + 954088 + 1931576 start 0x269068



Firmware Version 44.24

Duplex Console IO Dependent Code (IODC) revision 1



Stored message buffer up to panic:

System Panic:

linkstamp: Thu Apr 25 17:22:51 MDT 2002
_release_version: @(#)B2352B/9245XB HP-UX (B.11.00) #1: Wed Nov 5 22:38:19 PST 1997
__kern_ci_revision: $Header: kern_sequence.c,v 1.6.106.512 97/11/05 18:01:46 msosa Exp $

panic: set_machine_parameters_64: Unidentified cpu type returned from PDC_MODEL

PC-Offset Stack Trace (read across, top of stack is 1st):
0x0036a5fc 0x004fa468 0x004fa2c8
0x004f8860 0x00379b4c 0x0026959c
End Of Stack



*** A system crash has occurred. (See the above messages for details.)
*** The system is now preparing to dump physical memory to disk, for use
*** in debugging the crash.

ERROR: Your system crashed before I/O and dump configuration was complete.
A crash dump cannot be taken under these circumstances without
special configuration. Contact your HP support representative.

[Torsten.]

11.11 is the minimum supported version.

[Ivan Krastev]

Try to install 11.11 at least.
This version is not supported - see suport matrix here - http://h20338.www2.hp.com/hpux11i/downloads/public_hp-ux_systems_support.pdf

regards,
ivan

[Kapil Jha]

panic: set_machine_parameters_64: Unidentified cpu type returned from PDC_MODEL


It says and server dors not support 11.0
By the way we 11.00 is way old and out ofsupport...whay you trying to install.

Install a new verions.

BR,
Kapil+