System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Linux Bonding in Blade 460c G6

S.M.Athar
Advisor

Linux Bonding in Blade 460c G6

Hi,
I am facing problem in when I am configuring Network card bonding in RHEL 5.5. Please someone guide me. I am HP Bl460c G6 and the Ethernet switch is GBE2C L2/3.
I also disabled the cascading from 17 to 18 port.Can someone guide me.Is there configuration requires in both of the switch.
I configured the bonding but facing network issue like network delay etc.
Regards
Athar
2 REPLIES
Rob Leadbeater
Honored Contributor

Re: Linux Bonding in Blade 460c G6

Hi Athar,

Try adding the following to your /etc/modprobe.conf

options bnx2x disable_tpa=1

Cheers,

Rob
S.M.Athar
Advisor

Re: Linux Bonding in Blade 460c G6

Thanks for your prompt reply.
I am using Default Drivers, which was install during the OS installation.
I will try and let you know.
Confirm me is there any special configuration requires on switches end?