HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Problems using the ru command from the mp

 
SOLVED
Go to solution
likid0
Honored Contributor

Problems using the ru command from the mp

Hi,

I have some of my npars in an integrity sd32B superdome, not responding from the mp console, nor can I see the cell/iochassis status from the mp or the parstatus SO commands.

I've done a mp reboot(cm->xd), but no change.

now I wanted to try and reboot the pdhc bus with the ru command( I think i have sometime in the past used it for a simillar case)

But I get this permission error:

[sdconsol2] MP:CM> ru

Command Prohibited at this access level. Type HE for a list of commands.

I am using the Admin User:

LOGIN USER NAME STATUS PART. ACCESS

1 Admin Administrator All L,C,P,M,U,V

what do I have to modify to be able to use ru ?
Windows?, no thanks
2 REPLIES
Solution

Re: Problems using the ru command from the mp

To run the ru command you have to be in manufacturing mode. To get into that mode you need the support of the response centre - log a call with them and they should talk you through this if they deem it is necessary.

HTH

Duncan

HTH

Duncan
likid0
Honored Contributor

Re: Problems using the ru command from the mp

Ok, thnx for the answer
Windows?, no thanks