Problems while adding the member in Gicap

[manish_mpc]

BL2:root-/>icapmanage -u -m prod -h vpar1 Enter the password for root on vpar1:
ERROR: Cannot set up secure communication with vpar1.
This error can occur for a number of reasons. Verify that you have
access to the specified host and that it is running a compatible and
supported version of Instant Capacity.
ERROR: The following low-level error occurred:
CIM_ERR_INVALID_NAMESPACE: root/cimv2/npar

icapmanage command failed.

[Torsten.]

"running a compatible and
supported version of Instant Capacity."

This could be the problem.

[manish_mpc]

i have installed same version of icap & wbem which is running on my other member servers
which having v3 0909

[Torsten.]

This may help too:

http://bizsupport2.austin.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=110&prodSeriesId=3218564&prodTypeId=18964&objectID=c01664458

[manish_mpc]

i tried, but no luck

[Torsten.]

Did you check and reinstall all the WBEM providers?

[manish_mpc]

i have reinstalled wbem services not provider
shall i reinstall provder again

[manish_mpc]

I have reolved the issue. below are the acction taken from our side.
Problem: Certification Errors
1. remove GiCAPcert.pem & GiCAPpkey.pem files from /etc/opt/iCAP path from client.
2. remove clientname.pem file from /etc/opt/iCAP path of BL1
3. Regenerate the GiCAP keys:
# cd /etc/opt/iCAP
# ./GiCAP_keygen