HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Question regarding an Ignite recovery plan

 

Question regarding an Ignite recovery plan

If I create an Ignite ‘make_tape_receovery’ tape on an Itanium system can I use that tape to recovery ‘any’ other Itanium server or like the older versions of Ignite the servers hardware architecture is required to be very similar, to work properly. In this particular case I want to create an Ignite ‘make_tape_receovery’ tape on an rx8640 server and use that tape to restore an rx4640 server. Any thoughts?
1 REPLY
Steven E. Protter
Exalted Contributor

Re: Question regarding an Ignite recovery plan

Shalom,

An rx4640 is not a cell based server. An rx8640 is.

The hardware is very different.

This has been attempted in the past. It has failed and it has succeeded. You might find a golden image works better.

http://www.docs.hp.com/en/5992-5309/ch11s02.html

Bottom line is you need to test it. Due to hardware differences it could be a hard road.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com